Nios processor C program - Nios processor C program Hello, I'm using the DE0 board from altera and I wrote a little program to toggle an output pin from high level to low level and vice versa. That's my program : I'm not sure if he contains all the lines necessary to make my project work but, if it's the case, how can I convert my C program (I think that's the .elf) into an .sof for hardware application ? Thank you very much in advance for the replies, Sincerely Replies: Re: Nios processor C program yes thank you very much and sorry for my late reply Replies: Re: Nios processor C program Hi, Any concern or follow up? Have your problem resolved? Thanks, Best Regards, Sheng Replies: Re: Nios processor C program Hi, Make sure you're doing the steps correctly as stated in this video https://www.youtube.com/watch?v=joFaxLY-rUE . Based on Generate Completed window line 3, can you check the reason for causing that Failure compiling 'C:/Users/elyes/AppData...' . Alternatively, you can specify the HEX file with QIP. Best Regards, Sheng p/s: If any answer from community or Intel support are helpful, please feel free to mark as solution and give Kudos. Replies: Re: Nios processor C program and here the command for setting bits ; Replies: Re: Nios processor C program I tried to put my memory init in the on_chip_memory peripherals on Qsys to make a .sof file but it don't want to generate