DE10-Nano, IP UART, GPIO pins - DE10-Nano, IP UART, GPIO pins Hello. I would like to create a UART communication using IP core UART (RS-232 Serial Port) version 18.1 on the DE10-Nano kit and map it to the GPIO pins of the kit. Could I ask for advice if this is possible and how to implement it? Thank you for your help. Replies: Re: DE10-Nano, IP UART, GPIO pins Hi. Thank you for your support. Your answers have been great and helpful. I apologize for my delayed response. Replies: Re: DE10-Nano, IP UART, GPIO pins Hi Since a solution have been provided and no feedback was received, I shall set this thread to close pending. If you still need further assistance, you are welcome reopen this thread within 20days or open a new thread, some one will be right with you. Please login to ‘ https://supporttickets.intel.com’ , view details of the desire request, and post a feed/response within the next 15 days to allow me to continue to support you. After 15 days, this thread will be transitioned to community support. The community users will be able to help you on your follow-up questions. If you happened to close this thread you might receive a survey. If you think you would rank your support experience less than 10 out of 10, please allow me to correct it before closing or if the problem can’t be corrected, please let me know the cause so that I may improve your future service experience. Regards Jingyang, Teh Replies: Re: DE10-Nano, IP UART, GPIO pins Hi, Do you have any further update? Replies: Re: DE10-Nano, IP UART, GPIO pins Hi, Here are the screenshot examples to use UART to map to GPIO: 1)Exporting as conduit 2) Connect rx and tx to GPIO 3) Example of Pin Assignment assigning to board's GPIO with link of DE10 Nano user(page 29, table 3-10) manual: https://www.intel.com/content/dam/develop/external/us/en/documents/de10-nano-user-manual.pdf Thank you. Regards, Kelly Replies: Re: DE10-Nano, IP UART, GPIO pins Hi, Greetings and welcome to Intel's forum. Yes, it does support connection between UART to GPIO. The steps are: 1)Export the UART pins as conduit 2)Connect uart rx and tx to GPIO 3)Use pin assignment and assign it to the board's GPIO. I will attach a screenshot on the example steps for your reference. Thank you. Regards, Kelly Jialin, GOH