N-EMB-100 ZEKE EtherCAT Master_Slave - The N-EMB-100 platformThe N-EMB-100 is a high-performance industrial device platform equipped with an Cyclone® V SoC. It has two Arm Cortex-A9 processor cores and can use Linux, etc. in SMP mode. It… NDR boasts over 40 years of experience in embedded development, offering established technology essential for industrial systems, including FPGA design, circuit design, and OS porting.The Embedded… Cyclone® V SE FPGA The N-EMB-100 Platform is a platform primarily developed for the industrial Ethernet field. Equipped with a high-performance CPU board featuring a dual-core Arm Cortex A9 @925MHz, it allows for the use of operating systems such as Linux in SMP mode. It is the only board where both Gigabit Ethernet ports of the Arm processor are usable. Since the FPGA is equipped with two 10/100 PHYs, it is possible to use Altera's TSE MAC, etc. Industrial N-EMB-100 ZEKE EtherCAT Master_Slave Key Features The N-EMB-100 platform is a high-performance product specialized for the industrial Ethernet field. Offering Brief No Expansion: 2 x 100-pin 1.27mm pitch staggered connectors No No No Cyclone® V SE FPGA No DDR3 256M x 32-bit with 8-bit ECC, 400MHz - No Gigabit Ethernet: 2 x 10/100/1000 Mbps Ethernet ports (HPS sid) Fast Ethernet: 2 x 10/100 Mbps Ethernet ports (FPGA side) GPIO: Total 168 channels via expansion connectors (FPGA: 84CH + 74CH, HPS: 10CH) 17.1.0 Offering Brief Production a1JUi0000049UKXMA2 Input Voltage: 5.0V DC DIP Switches: 2 x 4-position DIP switches , User: 8 x Green LEDs What's Included Circuit diagrams Ordering Information N-EMB-100 a1JUi0000049UKXMA2 Production Boards / SOMs / Dev Kits a1MUi00000BO8slMAD a1MUi00000BO8slMAD Select 2026-05-27T00:09:56.000+0000 The N-EMB-100 platformThe N-EMB-100 is a high-performance industrial device platform equipped with an Cyclone® V SoC. It has two Arm Cortex-A9 processor cores and can use Linux, etc. in SMP mode. It has four RJ45 connectors: two ports for Arm-side Gigabit Ethernet and two ports for FPGA-side EtherCAT. Since it is equipped with two 10/100 PHYs on the FPGA side, it can also use Altera's TSE MAC IP, etc. QSPI or microSD cards can be used as boot memory, and the boot source can be selected with jumpers on the board. This board can be used in a variety of EtherCAT (hardware master/software master and slave) applications.Hardware Master: You can evaluate our hardware master using the Ethernet on the FPGA side.Software Master: You can implement various paid software masters using the Ethernet on the Arm side. We can also provide a demo environment with an open-source master stack implemented.Slave: It can also be used as a slave by implementing an EtherCAT slave IP, such as one made by BECKH Partner Solutions