How do I enable the USB-Blaster in the Quartus II Programmer on SUSE 11 Linux? - How do I enable the USB-Blaster in the Quartus II Programmer on SUSE 11 Linux? Description To enable the USB-Blaster™ cable in the Quartus® II Programmer on SUSE 11 Linux, perform the following steps: Add the following lines to the file /etc/udev/rules.d/51-usbblaster.rules : BUS=="usb", SYSFS{idVendor}=="09fb", SYSFS{idProduct}=="6001", MODE="0666", PROGRAM="/bin/sh -c 'K=%k; K=26061{K#usbdev}; printf /proc/bus/usb/%%03i/%%03i26061{K%%%%.*} 26061{K#*.}'", RUN ="/bin/chmod 0666 %c" BUS=="usb", SYSFS{idVendor}=="09fb", SYSFS{idProduct}=="6002", MODE="0666", PROGRAM="/bin/sh -c 'K=%k; K=26061{K#usbdev}; printf /proc/bus/usb/%%03i/%%03i26061{K%%%%.*} 26061{K#*.}'", RUN ="/bin/chmod 0666 %c" BUS=="usb", SYSFS{idVendor}=="09fb", SYSFS{idProduct}=="6003", MODE="0666", PROGRAM="/bin/sh -c 'K=%k; K=26061{K#usbdev}; printf /proc/bus/usb/%%03i/%%03i26061{K%%%%.*} 26061{K#*.}'", RUN ="/bin/chmod 0666 %c" Create a file named /etc/hotplug/usb/usbblaster and add the following lines to it: #! /bin/sh # /etc/init.d/usbblaster # ### BEGIN INIT INFO # Provides: usbblaster # Default-Start: 3 5 # Default-Stop: 0 1 2 6 # Short-Description: USB blaster # Description: USB blaster ### END INIT INFO USBDIR=/dev/bus/usb case "" in start) echo -n "Starting USB blaster" mkdir -p /.usbfs mount -n -t usbfs usbfs /.usbfs -obusmode=0700,devmode=0600,listmode=0644 ln -sf /.usbfs/devices /devices mount --rbind /proc/bus/usb ;; stop) echo -n "Stopping USB blaster" umount umount /proc/bus/usb ;; *) echo "Usage: ./21_2 {start|stop}" exit 1 ;; esac exit 0 Make the file executable. Complete your installation by setting up the programming hardware in Quartus II software. Details on this process can be found in Setting Up Programming Hardware in Quartus II software . Custom Fields values: ['novalue'] Troubleshooting novalue False ['novalue'] ['novalue'] novalue novalue ['Programmable Logic Devices'] ['novalue'] ['novalue'] ['novalue']