Why does the Ethernet link fail to come up during the U‑Boot stage after reboot on the Agilex® 5 FPGA 013B Dev Kit GSRD HPS? - Why does the Ethernet link fail to come up during the U‑Boot stage after reboot on the Agilex® 5 FPGA 013B Dev Kit GSRD HPS? Description Due to an issue in the Quartus® Prime Pro Edition software version 25.3.1 GSRD release for the Agilex® 5 FPGA 013B Development Kit, the Ethernet link may fail to initialize during the U‑Boot stage after a reboot. When the dhcp command is executed, the Ethernet connection does not come up successfully and the following error message is displayed: Resolution This problem is scheduled to be resolved in a future release of the Quartus® Prime Pro Edition Software. Additional Information This issue occurs only when a reboot is performed after a successful power‑on. During the initial power‑on boot, the problem does not occur because the operating system uses a generic Ethernet driver. The issue arises because the Micrel PHY driver is not enabled by default in the U‑Boot configuration, causing the Ethernet link to fail during subsequent boot cycles. Custom Fields values: ['novalue'] Troubleshooting 14026964882 novalue ['novalue'] ['FPGA Dev Tools Quartus® Prime Software Pro'] novalue 25.3 ['Agilex™ 5 FPGAs and SoCs'] ['novalue'] ['novalue'] ['novalue']