and gate acting as or and vysa versa - and gate acting as or and vysa versa hey I'm new to altera fpga , I've bought development board based on EP4CE6E22 cyclon IV and tryed to program it with basic program in quartus environment module my_and(a,b,c); input a,b; output c; assign c = a & b; endmodule I've loaded pin assignment from files that came with the board and programmed it with some chinese jtag blaster. but when i tryed to push one or the other or both (attached to a,b signals)button - the led turned on , and went off when released (like OR GATE) so i tryed to program it as OR GATE gate and the board started acting like AND GATE am i doing somthing wrong? Replies: Re: and gate acting as or and vysa versa Check the logic sense of your switches and LED pins. You are assuming PUSHed=1 and not=0, and out=1 for LED on, and out=0 for LED off. On many/most all boards pushbuttons will be connected to a pin with a pullup, so the default input will be a '1' (high). When you push it it goes to a '0' (low). The LED could be driven either active high ('1' high for ON, '0' low for OFF) or active low ('1' high for OFF, '0' low for ON). Check the schematic/docs for which way on your board.