Error(14566): The Fitter cannot place 1 periphery component(s) due to conflicts with existing constraints (1 PHYLITE_GROUP(s)). - Error(14566): The Fitter cannot place 1 periphery component(s) due to conflicts with existing constraints (1 PHYLITE_GROUP(s)). Description Due to the limitation of the PHY Lite for Parallel Interfaces Intel® FPGA IP, you may see the error message above if you have more than one PHY Lite for Parallel Interfaces Intel FPGA IP place in the same I/O bank. Resolution To work around this problem, avoid placing more than one PHY Lite for Parallel Interfaces Intel® FPGA IP place in the same I/O bank. This is because each of the PHY Lite for Parallel Interfaces Intel FPGA IP has a specific interface requirement which required a specific PLL setting. However, there is only one PLL available in a given bank. Custom Fields values: ['novalue'] Troubleshooting 1507413021 False ['novalue'] ['FPGA Dev Tools Quartus® Prime Software Pro', 'FPGA Dev Tools Quartus® Prime Software Standard'] novalue 19.3 ['Arria® 10 FPGAs and SoCs', 'Cyclone® 10 GX FPGA', 'Stratix® 10 FPGAs and SoCs'] ['novalue'] ['novalue'] ['novalue']