NIOS hex file does NOT get compiled into FPGA - NIOS hex file does NOT get compiled into FPGA Hi All, I had been building NIOS software for my MAX10 design and compiling it into the FPGA code for sometime when all of a sudden, the new NIOS software stopped compiling into the FPGA. Now when I compile the FPGA, I get an older version of the NIOS software compiled instead of the latest version. If I run the new software or debug it from NIOS SBT for Eclipse, it works perfectly. However, after I 1) "Make a new Target", 2) check that a new hex file has been created in the correct location, 3)check to be sure the Initialization of the On-Chip Memory in Qsys is pointing to the same hex file, and 4) compile the FPGA in Quartus Prime, I always get an old version of the software not the new build. Does anyone have any idea what is causing this to occur. I probably mistakenly set some switch or parameter to the wrong state, but I don't have a clue as to how to fix this situation. Thanks, Bill Replies: Re: NIOS hex file does NOT get compiled into FPGA Thanks Bill. Replies: Re: NIOS hex file does NOT get compiled into FPGA Yes you can close this Replies: Re: NIOS hex file does NOT get compiled into FPGA Hi, Bill Can I close this if you have no more inquiry ? Thanks. Eric Replies: Re: NIOS hex file does NOT get compiled into FPGA Hi, Bill May I know are you booting from on-chip RAM or on-chip flash of MAX10 ? To generate hex, you can follow, in your project folder, Make Targets->Build, click mem_init_generate and then Build to generate hex for on-chip RAM and on-chip flash for MAX10. Eric