what the best way to send data from FPGA to PC by JTAG communication? - what the best way to send data from FPGA to PC by JTAG communication? Hi, What is the best way to send data from FPGA to PC by JTAG Communication? I ask about JTAG because I have no more free communication line left and I need information to be transmitted at a fast rate (above 3MHz). Prefers a solution without use of NIOS. Also, which tool in Quartus is recommended for reading data from JTAG? Thank Replies: Re: what the best way to send data from FPGA to PC by JTAG communication? Following the previous question, I will detail the intention - I have a list of registers in the FPGA and I want to extract data from them at a fast rate (above 3MHz). This means that the data I have selected will be sent permanently until some stop conditions are reached. I am currently able to pull the data from the "jtag to avalon master bridge" in the System Console by commanding "master_read_32 $claim_path". Replies: Re: what the best way to send data from FPGA to PC by JTAG communication? I’m glad that your question has been addressed, I now transition this thread to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you. Replies: Re: what the best way to send data from FPGA to PC by JTAG communication? Hi Amir, You could use System Console or a JTAG bridge. These designs take advantage of Platform Designer and don't require Nios. Link to JTAG Bridge. It's on pages 57 and 149. https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_embedded_ip.pdf System Console user guide: https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_system_console.pdf Travis