Which Triple Speed Ethernet (TSE) MAC registers must be set to run a simulation? - Which Triple Speed Ethernet (TSE) MAC registers must be set to run a simulation? Description To configure the Altera® Triple Speed Ethernet (TSE) MegaCore® function for simulation, you need to set the MAC and PCS registers according to the table below. Please take note that command_config register should be the last register written because TSE operation will start when TX_EN and RX _EN in the command_config register are set. The order that the other registers are configured is not critical. Registers in bold are basically required configurations for TSE MAC and PCS respectively to start its operation. Table 1: MAC registers Register Offset Register Name Value Notes 0x08 command_config 0x400003B transmit and receive paths enabled, gigabit ethernet enabled, promiscuous mode enabled, RX frame padding removal enabled, RX erroneous frame discard enabled 0x04 scratch 0xAAAAAAAA N/A 0x0C mac_0 0x17231C00 MAC address of 0x001C23174ACB 0x10 mac_1 0x0000CB4A MAC address of 0x001C23174ACB 0x14 frame_length 0x533 Maximum frame length of 1518 bytes 0x18 pause_quant 0x0f N/A 0x1C RX_section_empty 0x10 N/A 0x20 RX_section_full 0x10 N/A 0x24 TX_section_empty 0x10 N/A 0x28 TX_section_full 0x10 N/A 0x2C RX_almost_empty 0x08 N/A 0x30 RX_almost_full 0x08 N/A 0x34 TX_almost_empty 0x08 N/A 0x38 TX_almost_full 0x0A N/A Table 2: PCS registers Register Offset Register Name Value Notes 0x00 PCS control 0x00000000 No features enabled 0x20 scratch 0x0000AAAA N/A 0x28 if_mode 0x00000009 Enable SGMII, SGMII speed - gigabit Custom Fields values: ['novalue'] Troubleshooting novalue False ['novalue'] ['novalue'] novalue novalue ['Programmable Logic Devices'] ['novalue'] ['novalue'] ['novalue']