ASMI IP to update the FPGA problem - ASMI IP to update the FPGA problem Hello everyone, I recently want to use ASMI's IP to update the content of FPGA, And my architecture is shown in Figure 1 My question is, After I deleted all the unused FF data after the .rpd file and wrote the EPCQ through ASMI, I could not successfully configure the FPGA after powering on again. I have compared the data before and after writing, and they are no different. Are there any suggestions for my approach? Thanks for your answers. Replies: Re: ASMI IP to update the FPGA problem Hi, thanks for your reply I have solved my problem. It’s my own problem, I thought the end message of .rpd was 2b c0(Fig) But later it was discovered that there were other messages besides FF. Replies: Re: ASMI IP to update the FPGA problem Hi, Thank you for contacting Intel community. Kindly refer to the ASMI user guide below and let us know your concern: ASMI I: https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_altasmi_parallel.pdf ASMI II: https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug-asmi2.pdf Regards, Aiman