How can I use the Quartus II programmer to program or configure my Altera device on a board in a remote location? - How can I use the Quartus II programmer to program or configure my Altera device on a board in a remote location? Description You can program or configure your Altera® device in a remote location using the Quartus® II programmer through your local computer by enabling JTAG over the network. The steps to enable JTAG over the network are described below: On the system hosting the programming hardware, open the command prompt (from the "start" menu, click run and type cmd), then enter “jtagconfig --enableremote <password>” Identify the host computer name by typing "hostname" on the command prompt. On your local computer, open the command prompt and type “jtagconfig --addserver <computer name> <password> You will be able to see the programming hardware located on the host computer in the Quartus II programmer running on the local computer. For more information on enabling JTAG, type "jtagconfig /?" in the command prompt. Custom Fields values: ['novalue'] Troubleshooting novalue False ['novalue'] ['novalue'] novalue novalue ['Programmable Logic Devices'] ['novalue'] ['novalue'] ['novalue']