N-EMB-110 ZEKE-G EtherCAT Master_Slave - The N-EMB-110 is a high-performance industrial device platform equipped with a Cyclone® V SoC. It has two Arm Cortex-A9 processor cores and can use Linux, etc. in SMP mode. It has four RJ45… NDR boasts over 40 years of experience in embedded development, offering established technology essential for industrial systems, including FPGA design, circuit design, and OS porting.The Embedded… Cyclone® V SE FPGA The N-EMB-110 Platform is a platform primarily developed for the industrial Ethernet field. Equipped with a high-performance CPU board featuring a dual-core Arm Cortex A9 @925MHz, it allows for the use of operating systems such as Linux in SMP mode. It is the only board where both Gigabit Ethernet ports and USB of the Arm processor are usable. Since the FPGA is equipped with two 10/100/1000 PHYs, it is possible to use Altera's TSE MAC, etc. Industrial N-EMB-110 ZEKE-G EtherCAT Master_Slave Key Features The N-EMB-110 platform is a high-performance product specialized for the industrial Ethernet field. Offering Brief No Expansion: 2 x 100-pin 1.27mm pitch staggered connectors No No No Cyclone® V SE FPGA No RAM: DDR3 256M x 32-bit with 8-bit ECC, 400MHz - No HPS (Arm) Ethernet: 2 x Gigabit Ethernet (10/100/1000 Mbps) ports FPGA Ethernet: 2 x Gigabit Ethernet (10/100/1000 Mbps) ports USB: Fully supported GPIO: Total 168 channels via expansion connectors 17.1.0 Offering Brief Sampling a1JUi0000049UKWMA2 Input Voltage: 5.0V DC User: 8 x Green LEDs (4 for HPS, 4 for FPGA) / DIP Switches: 3 x 4-position DIP switches What's Included Schematics Ordering Information N-EMB-110 a1JUi0000049UKWMA2 Sampling Boards / SOMs / Dev Kits a1MUi00000BO8slMAD a1MUi00000BO8slMAD Select 2026-05-27T00:11:25.000+0000 The N-EMB-110 is a high-performance industrial device platform equipped with a Cyclone® V SoC. It has two Arm Cortex-A9 processor cores and can use Linux, etc. in SMP mode. It has four RJ45 connectors: two ports for Arm-side Gigabit Ethernet and two ports for FPGA-side EtherCAT. It also has four USB ports available. Since it is equipped with two 10/100/1000 PHYs on the FPGA side, it can also use Altera®'s TSE MAC IP, etc. QSPI or microSD cards can be used as boot memory, and the boot source can be selected with jumpers on the board. This board can be used in a variety of EtherCAT (hardware master/software master and slave) applications.Hardware Master: You can evaluate our hardware master using the Ethernet on the FPGA side.Software Master: You can implement various paid software masters using the Ethernet on the Arm side. We can also provide a demo environment with an open-source master stack implemented.Slave: It can also be used as a slave by implementing an EtherCAT slave IP, such Partner Solutions