Questions about using Remote Update IP core - Questions about using Remote Update IP core Hello, I'm using Remote Update IP core in my design. The device is cyclone 10LP, and the configuration device is EPCQ64A. I set the boot address of the application image as 0x400_000 which is half of the address space of the flash device. But when I was debugging my design, I found that, although the application image was loaded on the FPGA, the value of the boot address of this image I read was wrong. I wonder if there's any detail I ignored? The parameters I set were as follows. And the value I read is 0x1_000_000 which is wrong. Thank you! Replies: Re: Questions about using Remote Update IP core Hi, Any update fort this request? Else, I will proceed to close this case. Thanks. Regards, Aiman Replies: Re: Questions about using Remote Update IP core Hi, Thank you for contacting Intel community. Apologize for the delay in response as this case was only routed to me today. I am assuming you have follow this design example, but having problem with the boot address? https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_altremote.pdf 2.Please let me know if my understanding is correct or not. If you are following the design example, do you check on the design example? https://fpgacloud.intel.com/devstore/platform/17.0.0/Standard/cyclone-10-lp-remote-system-update-design-example/ Regards, Aiman