How do you export the EMIF Toolkit full calibration and margin report in one file? - How do you export the EMIF Toolkit full calibration and margin report in one file? Description In the Quartus® II software version 12.1 and later, there is an issue with the EMIF Toolkit exporting the calibration report in a single file. It only allows exporting of each individual section of the report. Resolution The following workaround can be used to export the full calibration report : After running the "Generate Margining Report" command, type the following tcl command in the EMIF toolkit console: write_connection_target_report -id <id_value> -file "<report_name>" where <id_value> is the Connection ID of the memory interface shown in the Connections Report -> Linked Connections. An example command is : write_connection_target_report -id 0 -file "report0.rpt" This issue has been fixed in the Quartus II software 13.1 release. Custom Fields values: ['novalue'] Troubleshooting 2205802253 False ['DDR3 SDRAM Controller with UniPHY IP'] ['FPGA Dev Tools Quartus II Software'] 13.1 12.1 ['Arria® II GZ FPGA', 'Arria® V GT FPGA', 'Arria® V GX FPGA', 'Arria® V GZ FPGA', 'Arria® V ST FPGA', 'Arria® V SX FPGA', 'Cyclone® V E FPGA', 'Cyclone® V GT FPGA', 'Cyclone® V GX FPGA', 'Cyclone® V SE FPGA', 'Cyclone® V SX FPGA', 'Stratix® III FPGAs', 'Stratix® IV E FPGA', 'Stratix® IV GT FPGA', 'Stratix® IV GX FPGA', 'Stratix® V E FPGA', 'Stratix® V GS FPGA', 'Stratix® V GT FPGA', 'Stratix® V GX FPGA'] ['novalue'] ['novalue'] ['novalue']