Why am I seeing a non-fatal error, “Firmware Error Detected” during hardware testing when using the F-Tile Dynamic Reconfiguration Suite IP? - Why am I seeing a non-fatal error, “Firmware Error Detected” during hardware testing when using the F-Tile Dynamic Reconfiguration Suite IP? Description Due to a problem in Quartus® Prime Pro Edition Software version 24.3, you may see a non-fatal error “Firmware Error Detected” (error code 0x1F) during hardware testing when using F-Tile Dynamic Reconfiguration Suite IP for FHT designs. The error may look like the screenshot below: Resolution This is a non-fatal error (error code 0x1F), so it can be ignored. If you see this “Firmware Error Detected” error, and the test is failing, you can follow the steps below: ) Navigate to “../[example design]/hardware_test_design/hwtest/tests/ftile_eth_dr_test.tcl” ) Search for “ dr_firmware_error ” code ) Comment line #639 as shown below: ) Re-run the test. ) If the test passes, despite a firmware error with the same value in the log as the previous test, it confirms that the previous test error is non-fatal and can be ignored. ) Uncomment line #639 to make sure other Firmware errors are detected and the non-fatal error (error code 0x1F) can be ignored. This problem is fixed beginning with the Quartus® Prime Pro Edition software version 24.3.1. Custom Fields values: ['novalue'] Troubleshooting 14023417934 False ['F-Tile Dynamic Reconfiguration Suite IP'] ['FPGA Dev Tools Quartus® Prime Software Pro'] 24.3.1 24.3 ['Agilex™ 5 FPGAs and SoCs', 'Agilex™ 7 FPGAs and SoCs'] ['novalue'] ['novalue'] ['novalue']