I Can not run my Nios II program, because of "Project does not have an ELF file" - I Can not run my Nios II program, because of "Project does not have an ELF file" Hello,friends there is a problem when i used Nios II, "project does not have an ELF file, Please make sure project has been built successfully", Do anyone kown this issue? Thanks Replies: Re: I Can not run my Nios II program, because of "Project does not have an ELF file" You are welcome , I will consider this case is closed. Replies: Re: I Can not run my Nios II program, because of "Project does not have an ELF file" The FPGA is Cyclone 10, I have solved the issue by increasing the RAM. Thank you so much! Replies: Re: I Can not run my Nios II program, because of "Project does not have an ELF file" Hi, 8192 Bytes is small for an application, please let me know what device family you are using? I normally start with 64000 Bytes and see if the application will fit or not. Regards, Replies: Re: I Can not run my Nios II program, because of "Project does not have an ELF file" Replies: Re: I Can not run my Nios II program, because of "Project does not have an ELF file" Hi, It is on chip memory,and the size as following: RAM on chip is 8192bytes ROM on chip is 8192bytes I tried to set the size of RAM and ROM is 4096bytes, but the issue is still.. Replies: Re: I Can not run my Nios II program, because of "Project does not have an ELF file" Hi, What is the size for your on-chip memory that been vectored as reset memory and exception memory? if it is not an on-chip memory please let me know. It is mainly the size isn't enough or the bsp setting isn't the correct setting for the chosen memory. Regards,