Does Quartus generate a "Unused Signal" report for modules that it compiles? - Does Quartus generate a "Unused Signal" report for modules that it compiles? Can Quartus generate a "Unused Signal" report for modules that it compiles? if so, how is it turned on and/or viewed? Replies: Re: Does Quartus generate a "Unused Signal" report for modules that it compiles? Thanks for your assitance with this question Replies: Re: Does Quartus generate a "Unused Signal" report for modules that it compiles? Hi, after running synthesis, should see the .syn.rpt being generated check screenshot attahced. Or in GUI, go to compilation report -> Synthesis -> Warning Messages compilation report -> Synthesis -> Partition "root_partition" -> Optimization Results -> Register Statistics -> Register Removed During Synthesis Check screenshot attached. Thanks, Sheng Replies: Re: Does Quartus generate a "Unused Signal" report for modules that it compiles? Hi ShengN, I was not able to locate the *.syn.rpt file in the output directory or anywhere else in an of the other project directories. Does it have another name or is it located somewhere else? Thanks for your timely reponse. WShep1 Replies: Re: Does Quartus generate a "Unused Signal" report for modules that it compiles? Hi, Any further concern or update? Thanks, Best Regards, Sheng Replies: Re: Does Quartus generate a "Unused Signal" report for modules that it compiles? Hi, Can check the .syn.rpt in output_files folder under section Warnings for <module_name> and Registers Removed During Synthesis . Will have reasons like Pin "" is stuck at GND or Lost fanout . Thanks, Best Regards, Sheng p/s: If any answer from the community or Intel Support are helpful, please feel free to give best answer or rate 4/5 survey.