Why does the Low Latency Ethernet 10G MAC's dynamic generated multi-rate example design fail compilation for Stratix 10 device? - Why does the Low Latency Ethernet 10G MAC's dynamic generated multi-rate example design fail compilation for Stratix 10 device? Description Due to a problem with Intel® Quartus® Prime version 17.1, the Low Latency Ethernet 10G MAC's dynamically generated multi-rate example design will fail compilation if the "Analog Voltage" setting is changed to 1_1V in Low Latency Ethernet 10G MAC example design GUI. The following are the affected multi-rate example design variants: 10G USXGMII Ethernet Example Design (Intel® Stratix® 10) 10M/100M/1G/2.5G/10G Ethernet Example Design (Stratix 10) 1G/2.5G Ethernet with 1588 Example Design (Stratix 10) 1G/2.5G/10G Ethernet with 1588 Example Design (Stratix 10) Resolution To work around this problem, launch the IP Parameter Editor of the following IPs from the generated multi-rate example design project, and manually change the setting for "VCCR_GXB and VCCT_GXB support voltage for the Transceiver" to 1_1V. Stratix 10 L-Tile/H-tile Transceiver fPLL (Open the .ip files which located in <project_directory>\rtl\pll_fpll and change the settings) Stratix 10 L-Tile/H-tile Transceiver ATX PLL (Open the .ip files which located in <project_directory>\rtl\pll_atxpll and change the settings) 1G/2.5G/5G/10G Multi-rate Ethernet PHY (Open the .ip file which located in <project_directory>\rtl\phy and change the settings) This problem has been fixed in Quartus Prime version 17.1.1. Custom Fields values: ['novalue'] Troubleshooting FB: 519805; True ['Low Latency Ethernet 10G MAC IP'] ['FPGA Dev Tools Quartus® Prime Software Pro'] 17.1.1 17.1 ['Stratix® 10 FPGAs and SoCs'] ['novalue'] ['novalue'] ['novalue']