Error while running University Program waveform - Error while running University Program waveform So,guys, I am trying to debug my Bram module that I have used.My FPGA board is altera de-2 115 cyclone 2 device family with ep2c35 serial. This is my block ram code which is used to initialize the ram with hex data of pictures coverted using matloab. module bram_p(clk,inbus,outbus,addr,we); parameter DATAFILE="Sample80x80.hex"; parameter RAM_WIDTH =24; parameter RAM_ADDR_BITS=13; parameter INIT_START_ADDR= 0; parameter INIT_END_ADDR=6399; input clk,we; input [RAM_WIDTH-1:0]inbus; output reg [RAM_WIDTH-1:0]outbus; input [RAM_ADDR_BITS-1:0]addr; (* ramstyle = "M4K" *)reg[RAM_WIDTH-1:0]mem[(2**RAM_ADDR_BITS)-1:0]; initial begin $readmemh(DATAFILE,mem, INIT_START_ADDR, INIT_END_ADDR); end always @(posedge clk)begin if (we)begin mem[addr] <=inbus; end outbus<=mem[addr]; end endmodule I have attached the hex fille and the warning images I get when I tryh to simulate using UWF Replies: Re: Error while running University Program waveform Yes, I managed to make the University Waveform Program work, I didn't understand why it didn't work in the first place. But after creating a new project wizard and running the code in a different location, it worked perfectly. I am sorry for the late reply and thanks for your reply to my post Replies: Re: Error while running University Program waveform Hi, May I know if there is any update? Replies: Re: Error while running University Program waveform Hi, May I know if there is any update? Replies: Re: Error while running University Program waveform From the error message snapshot, I can see your path name Image_processing with verilog. Try to remove the space and simulate it again.