3.9.3. Running the RX-Only Design - 2025-12-16

F-Tile HDMI IP Design Example User Guide
Version
24.3

Before running the RX-only design, program the design, set the DIP switches, and adjust the clock settings according to the instructions in Compiling and Testing the Design.

For the RX-only design, all resolutions that are valid based on the HDMI specification are supported.

Run the RX-only design by following these steps:

Rebuild the software and run the new .elf file as follows:
  1. Start a Nios® V Command Shell session.
  2. Download the .elf file with the following command:
  3. Start a JTAG UART terminal session with the following command: 
    juart-terminal -i 0
    This command generates output similar to the following example output:
    ******************************************
*** Intel Agilex AXI Design (HDMI 2.1) ***
******************************************

System startup...
DS125BR820 RX=00
Configure RX EDID Max FRL capability to FRL rate 6

System startup complete

----------------------------------------------
RX achieves stable alignment lock and video lock
RX is running at FRL rate 6
CVI is locked


        RX VIC                  : 97
        H-activexV-active       : 3840x2160  (Progressive)
        Color Space             : : RGB 8-Bit

HDMI RX: Lost video lock

----------------------------------------------
RX achieves stable alignment lock and video lock
RX is running at FRL rate 6