AN 717: Nios II Gen2 Hardware Development Tutorial - 2014-09-22

1. Hardware Development Tutorial
1.1. Software and Hardware Requirements
1.2.
1.3. Design Example
1.4. System Development Flow
1.4.1. Analyzing System Requirements
1.4.2. Defining and Generating the System in
1.4.3. Integrating the System into the Project
1.4.4. Developing Software with the Software Build Tools for Eclipse
1.4.5. Running and Debugging Software on the Target Board
1.4.6. Varying the Development Flow
1.5. Creating the Design Example
1.5.1. Install the Design Files
1.5.2. Analyze System Requirements
1.5.3. Start the Software and Open the Example Project
1.5.4. Create a New System
1.5.5. Define the System in
1.5.5.1. Specify Target FPGA and Clock Settings
1.5.5.2. Add the On-Chip Memory
1.5.5.3. Add the Processor Core
1.5.5.4. Add the JTAG UART
1.5.5.5. Add the Interval Timer
1.5.5.6. Add the System ID Peripheral
1.5.5.7. Add the PIO
1.5.5.8. Specify Base Addresses and Interrupt Request Priorities
1.5.5.9. Generate the System
1.5.6. Integrate the System into the Project
1.5.6.1. Instantiate the System Module in the Project
1.5.6.2. Add IP Variation File
1.5.6.3. Assign FPGA Device
1.5.6.4. Assign FPGA Pin Locations
1.5.6.5. Set Timing
1.5.6.6. Compile the Project and Verify Timing
1.5.7. Download the Hardware Design to the Target FPGA
1.5.8. Develop Software Using the SBT for Eclipse
1.5.8.1. Create a New Application and BSP from Template
1.5.8.2. Compile the Project
1.5.9. Run the Program on Target Hardware
1.6. Document Revision History

Back to home page