4.10.1. Estimating E-Tile Channel PLL Power with the Power and Thermal Calculator - You can estimate E-tile channel PLL power for Stratix 10 devices, by adding a Transmitter-only row to the Transceiver page of the Power and Thermal Calculator (PTC).

You can estimate E-tile channel PLL power for Stratix^® 10 devices, by adding a Transmitter-only row to the Transceiver page of the Power and Thermal Calculator (PTC).

The following three examples illustrate the PTC configuration for various E-tile channel PLL requirements.

Table 23. E-Tile Channel PLL configured for: Reference clock = 200MHz, pll_clkout1 = 800MHz, pll_clkout2 = 400MHz
Operation Mode	Data Rate	Digital/Analog Width	Power Mode	FEC	EHIP	Modulation	Digital Freq	# Refclks	Refclk Freq	VOD
Transmitter Only	12800	16	Normal Power	Bypass	Bypass	NRZ	0	1	200	0

Table 24. E-Tile Channel PLL configured for: Reference clock = 125MHz, pll_clkout1 = 500MHz, pll_clkout2 = 250MHz
Operation Mode	Data Rate	Digital/Analog Width	Power Mode	FEC	EHIP	Modulation	Digital Freq	# Refclks	Refclk Freq	VOD
Transmitter Only	8000	16	Normal Power	Bypass	Bypass	NRZ	0	1	125	0

Table 25. E-Tile Channel PLL configured for: Reference clock = 307MHz, pll_clkout1 = 491MHz, pll_clkout2 = 245MHz
Operation Mode	Data Rate	Digital/Analog Width	Power Mode	FEC	EHIP	Modulation	Digital Freq	# Refclks	Refclk Freq	VOD
Transmitter Only	19660.8	40	Normal Power	Bypass	Bypass	NRZ	0	1	307	0

Alternatively, you can instantiate an E-Tile Transceiver-native PHY IP in PLL mode in your Quartus^® Prime project, compile the project, and view the configuration in the PTC.

4.10.1. Estimating E-Tile Channel PLL Power with the Power and Thermal Calculator - You can estimate E-tile channel PLL power for Stratix 10 devices, by adding a Transmitter-only row to the Transceiver page of the Power and Thermal Calculator (PTC). - 2025-12-16

Power and Thermal Calculator User Guide